Free shippingOn every online order shipped within the contiguous U.S. Valid only for orders placed through our website.
Safety Through Innovation · Made in the USA
Free shippingOn every online order shipped within the contiguous U.S. Valid only for orders placed through our website.
Bench Grinders
Showing all 13 products
A bench grinder’s wheel turns at high speed and stores a lot of energy. The main hazards are a wheel that bursts, a part that wedges between the work rest and the wheel and cracks it, and a hand that slips onto the wheel face. Sparks and grit fly toward the eyes and face, and a grinder left switched on will start again by itself when power is restored after an outage.
Under OSHA 1910.215, the wheel guard must cover the spindle end, nut and flange projections. The general requirements call for the work rest on an offhand grinder to be kept within 1/8 inch of the wheel, clamped after each adjustment and never adjusted while the wheel is turning, and the same section limits the gap between the wheel and the adjustable tongue at the top of a bench or floor stand guard to 1/4 inch. Both gaps widen as the wheel wears. The No-Go bench grinder safety gauge (magnet) stores on the machine for daily checks, the wire version stays tethered to the grinder, and the bench grinder adjustment safety kit adds magnetic tools for wheel adjustments.
On the consensus side, ANSI B11.9 sets requirements for stationary grinding machines such as bench and pedestal grinders, from design and installation through operation and maintenance. See also grinder safety tools and gauges and grinding wheels.
OSHA 1910.215 limits the work rest to 1/8 inch from the wheel and the gap between the wheel and the adjustable tongue guard to 1/4 inch. The rest must be clamped after each adjustment, and adjustments must never be made while the wheel is turning. Check both gaps often, because they widen as the wheel wears.
OSHA 1910.215(d) requires the user to inspect and ring test every wheel immediately before mounting: tap it gently with a light nonmetallic tool and do not use it if it sounds dead. Also check that the spindle speed does not exceed the maximum operating speed marked on the wheel.
Both versions are used to check bench grinder gaps. The magnetic gauge stores directly on the machine so it is at hand for daily checks, while the wire version is permanently tethered to the grinder so it cannot go missing. The adjustment safety kit pairs the gauge with magnetic tools.
The No-Go grinder safety stand is offered for new or used bench grinders, with options for 120 VAC grinders under 15 amps and for 208-230/460 VAC machines. Its work rest sensors block start-up whenever a rest is set out of specification, and its contactor keeps the grinder off after a power loss until someone restarts it.