Free shippingOn every online order shipped within the contiguous U.S. Valid only for orders placed through our website.
Safety Through Innovation · Made in the USA
Free shippingOn every online order shipped within the contiguous U.S. Valid only for orders placed through our website.
Custom belt guards and motor-to-pump coupling guards that enclose rotating power transmission parts.
Showing all 2 products
Belt drives and shaft couplings run whenever the motor runs, on pumps, compressors, fans and other equipment that people work beside. Where a belt runs onto a pulley, the in-running nip point can draw in fingers, gloves or a sleeve, and the bolts, setscrews and revolving surfaces of a coupling can catch loose clothing. A fixed guard enclosing the drive prevents that contact while the machine runs.
OSHA 1910.219, the standard for mechanical power-transmission apparatus, sets guarding rules by height. Pulleys with any part 7 feet or less from the floor or working platform must be guarded, and exposed horizontal shafting within that 7 feet needs a stationary casing or a trough. Where both runs of a horizontal belt are 42 inches or less from the floor, the belt must be fully enclosed, and vertical and inclined belts must be enclosed too. Shaft couplings must present no hazard from bolts, nuts, setscrews or revolving surfaces.
The section names suitable guard materials, including expanded metal, perforated or solid sheet metal and wire mesh on a frame, and calls for metal free of burrs and sharp edges. On woodworking machinery, 1910.213(a)(9) requires belts, pulleys, gears and shafts to be guarded to 1910.219. The general rules in 1910.212(a) call for guards to be affixed to the machine where possible and not to create a hazard themselves, and ANSI B11.0 describes the risk assessment process for deciding what safeguarding a machine needs.
Conveyor drives and flat guard panels are in conveyor and belt guards, and clear shields and one-off designs are in general guards and shields. Browse every guard type in machine guarding, or book a machine risk assessment to find unguarded drives.
Four. The custom belt guard product image shows each of the four dimensions to measure on your drive. Match each measurement to the dimension options on the product, and Odiz builds the guard to the dimensions you select. If your drive does not fit the options, ask Odiz for a custom quote.
OSHA 1910.219 requires shaft couplings to present no hazard from bolts, nuts, setscrews or revolving surfaces, and requires exposed horizontal shafting 7 feet or less from the floor or working platform to be enclosed by a stationary casing or trough. A guard that encloses the coupling and the exposed shaft ends between motor and pump addresses both hazards.
Under OSHA 1910.219, a horizontal belt must be fully enclosed when both runs are 42 inches or less from the floor. If both runs are higher but still 7 feet or less from the floor, the guard must extend at least 15 inches above the belt or to a standard height. Vertical and inclined belts must be enclosed.
OSHA 1910.219 requires power-transmission equipment to be inspected at intervals not exceeding 60 days and kept in good working condition, and belts, lacings and fasteners must be inspected and kept in good repair. Shut down and lock out the drive before removing a guard, and refit the guard before the machine restarts.