Free shippingOn every online order shipped within the contiguous U.S. Valid only for orders placed through our website.
Safety Through Innovation · Made in the USA
Free shippingOn every online order shipped within the contiguous U.S. Valid only for orders placed through our website.
Belt and disc sander guarding, No Go™ belt and disc finishing machines and sanders, MAKESafe stands and power loss drop-out controls.
Showing all 5 products
On a belt sander, the nip point where the belt runs onto each pulley can pull in a fingertip or glove. The unused run of the belt and the exposed part of a disc below the table add contact and abrasion hazards, and a small part can be dragged into the gap between the work rest and the abrasive when the rest is set too far back. A sander that restarts by itself after a power outage can start up under someone’s hands.
OSHA’s general requirement in 1910.212 calls for guarding against ingoing nip points and rotating parts on every machine. For woodworking sanders, the sanding machine rules in 1910.213(p) are more specific: a disc sander needs an exhaust hood or guard enclosing the disc except the portion above the table, and a belt sander needs guards at each nip point where the belt runs onto a pulley, with the unused run of the belt guarded against accidental contact. For sanding dust, see grinding and finishing dust collection; for wheel grinders, see bench grinders.
Yes. Odiz belt and disc sander guarding is sold as a complete guarding solution or as one portion. The disc guarding works with individual or combination units, and the belt side can take the adjustable top guard, the lower belt guard or both. For a custom feature or design, contact Odiz.
OSHA's 1/8 inch work rest limit appears in the abrasive wheel rule for offhand grinding machines. For woodworking sanders, OSHA's specific rules focus on guarding the belt nip points, the unused run of the belt and the disc. No-Go belt sanders still hold the work rest to 1/8 inch and will not start when it is set wider.
The No-Go control uses a motor contactor, so the sander drops out when power is lost and stays off when power returns. The operator has to press start again, and the work rest sensors must confirm the rest is within limits before the motor will run.