Safety Through Innovation · Made in the USA
OSHA 1910.212(a)(3)(iv) lists machine types that typically require point-of-operation guarding, including guillotine cutters, shears, alligator shears, power presses, milling machines, power saws, jointers, portable power tools, and forming rolls and calenders.
27 products
OSHA 29 CFR 1910.212(a)(3)(iv) provides a representative list of machines that usually require point-of-operation guarding because their normal operation exposes employees to cutting, crushing, shearing, or amputation hazards at the point where work is performed on the material. This list helps employers quickly identify equipment where a guard or safeguarding device is typically necessary to prevent hand, finger, or body entry into danger zones.
These examples are drawn directly from OSHA’s regulatory text and are not exhaustive; any machine that exposes an employee to injury at the point of operation must be guarded.
The phrase “usually require” signals that, in typical use, these machines present recognized hazards at the point of operation. Employers must evaluate the actual setup and task. If exposure exists, the machine must have effective guarding or safeguarding devices that prevent entry into the danger zone during operation.
No. It is representative. Any machine that exposes an employee to injury at the point of operation requires guarding, even if not named here.
They “usually require” guarding when the task creates exposure at the tool’s point of operation (e.g., cutting edges on saws). Evaluate the specific tool and use case.
Yes, if they provide equivalent or better protection by preventing any part of the body from entering the danger zone during the operating cycle.
Showing all 27 products