OSHA 1910.212(a)(3)(iv)(d) — Power Presses
OSHA 29 CFR 1910.212(a)(3)(iv)(d) lists power presses among the machines that usually require point-of-operation guarding.
Power presses—whether mechanical, hydraulic, or pneumatic—use high force and rapid motion to punch, form, or shape metal and other materials.
Because the operator often works close to the die area, these machines present one of the highest risks of amputation, crushing, and pinch-point injuries in manufacturing.
Understanding the Hazard
The point of operation on a power press is where the upper die or ram descends to meet the lower die or workpiece.
Any body part entering this zone during cycling can be instantly crushed or severed.
OSHA requires employers to use physical guards or safeguarding devices that eliminate the possibility of hand or finger entry while the press is in motion.
Primary Safeguarding Methods for Power Presses
- Fixed barrier guards: Enclose the die area with openings too small for hand or finger access.
- Adjustable barrier guards: Allow different stock sizes while maintaining full coverage of the hazard zone.
- Interlocked barrier guards: Prevent press cycling unless the guard is closed; opening it stops motion immediately.
- Presence-sensing devices (light curtains): Stop the press stroke if the sensing field is interrupted before the die closes.
- Two-hand controls: Require the operator to press two buttons simultaneously to cycle the press, ensuring both hands are outside the danger zone.
- Pull-backs or restraint devices: Physically remove or restrict the operator’s hands from entering the die space during the stroke.
Design and Performance Requirements
- Safeguards must prevent any part of the body from entering the point of operation during the downstroke.
- Guards must be durable, securely attached, and tamper-resistant.
- Safeguarding devices must be fail-safe—a failure should stop the machine, not allow cycling.
- Controls must include anti-tie-down and anti-repeat features so operators cannot bypass protection.
- Emergency stop controls must be accessible and tested regularly.
Types of Power Presses Covered
- Mechanical stamping presses
- Hydraulic forming presses
- Pneumatic or air-powered presses
- Flywheel-driven punch presses
- Brake presses used for bending and forming
Common Violations
- Operating presses without point-of-operation guards or safety devices installed.
- Disabled or bypassed interlocks and light curtains.
- Failure to perform required safety device inspections and die-setting checks.
- Inadequate control reliability or anti-repeat functions.
- Improper use of hand tools instead of engineering controls for feeding or removing material.
Best Practices for Compliance
- Install and maintain engineered safeguarding—avoid relying solely on work rules or procedures.
- Conduct daily safety checks of guards, light curtains, and two-hand controls before production begins.
- Train die setters and operators on control system function, safe distances, and response testing.
- Inspect and document safety system function after every die change or maintenance event.
- Lockout and tag out power sources before clearing jams or making adjustments.
Related Considerations
In addition to 1910.212(a)(3)(iv)(d), OSHA maintains a specific standard—1910.217, Mechanical Power Presses—that details inspection, maintenance, and control reliability requirements for these machines.
Section 1910.212 remains applicable to all press types, including hydraulic and pneumatic models not covered by 1910.217, reinforcing the need for comprehensive point-of-operation safeguarding.
Why OSHA 1910.212(a)(3)(iv)(d) Is Important
Power presses are among the leading sources of workplace amputations in metal fabrication and stamping.