Safety Through Innovation · Made in the USA

This machine guarding Gotcha Stick is an inspection gauge that checks whether guard openings are small enough to keep hands and fingers from reaching a hazard. If the gauge can touch the equipment through any gap, the guard does not meet the requirement. Made in the USA for OSHA 1910.217 guard inspections.
Not sure where to start? Reach out to our team to learn more.
The Odiz Machine Guarding Gotcha Stick verifies that machine guard openings are sized to prevent hands and fingers from reaching hazards. Use it during machine guarding inspections to check guards against OSHA requirements: insert the gauge into each gap, and if it can touch the equipment through any gap, the guard does not meet the requirement. The gauge has segments that apply to the applicable standards, so use the segment that matches the requirement for the opening you are checking.
The Gotcha Stick is used to check guards against OSHA 1910.217, mechanical power presses, which requires point of operation guards to conform to the maximum permissible openings of Table O-10; in that table, the allowed width of an opening depends on its distance from the point of operation hazard. A gauge check supports, but does not replace, a machine guarding risk assessment.
Use the gauge on H-frame, horizontal and vertical presses, press brakes, ironworkers, pipe benders, rollers and shears during guarding inspections, after a guard is installed or modified, and in EH&S audits. For help determining machine guarding risks, see the Odiz machine guarding risk assessment page or contact the Odiz EH&S Machine Guarding services group.
The user accepts the risk and responsibility for the proper use of this tool, including the segments that apply to the applicable standards, and agrees that Odiz Safety LLC is not liable for injuries or damage related to improper use.
OSHA’s safety requirements for mechanical power presses, covering press construction and brakes, point-of-operation guards and safeguarding devices, safety distances, inspection and maintenance, operator training and injury reporting.

Odiz builds custom hydraulic press guards that fit around your process and/or part, with steel and/or Lexan po…
Request quote
SKU ODIZ-5928

If you are looking for assistance with Machine Stop Measurements and Safety Device Validation Please contact u…
Request quote
SKU ODIZ-7277

This stop/E-stop foot pedal bar lets an operator stop a lathe, milling machine or other machine with a foot. T…
$1,350.00
SKU ODIZ-7226

Pressure‑sensitive body bars are emergency‑trip devices required on rubber‑industry mills with roll heights at…
$1,350.00
SKU ODIZ-8527