OSHA 1910.212(a)(3)(iii) — Special Hand Tools for Placing and Removing Material
OSHA 29 CFR 1910.212(a)(3)(iii) covers special hand tools used to place material into, or remove it from, the point of operation. The regulation states that these tools "shall be such as to permit easy handling of material without the operator placing a hand in the danger zone" and that they "shall not be in lieu of other guarding required by this section, but can only be used to supplement protection provided."
What the requirement means
- Special hand tools supplement point of operation guarding; they never replace it. The guarding required by 1910.212(a)(3)(ii) must still be in place.
- The tools must let the operator handle material easily, so there is no need to reach into the danger zone.
- Tools should suit the specific machine and material and be kept in good condition.
Examples of special hand tools
- Tongs, pliers and holders for feeding or removing parts
- Push sticks and push blocks
- Hook tools and magnetic or vacuum lifters for retrieving parts
Common mistakes
- Using hand tools instead of a guard.
- Using worn, shortened or improvised tools that bring hands closer to the hazard.
- Not training operators on when and how to use the tools.
Related requirements
1910.212(a)(3)(i) defines the point of operation, 1910.212(a)(3)(ii) requires it to be guarded, and 1910.212(a)(3)(iv) lists machines that usually require point of operation guarding.