Safety Through Innovation · Made in the USA
OSHA 1926.304(g) sets safety requirements for radial saws in construction, including guarding, non-kickback devices, and automatic return to safe position. These rules protect workers from lacerations, kickbacks, and other saw-related hazards.
1 products
OSHA 29 CFR 1926.304(g) establishes safety requirements for radial saws used in construction.
Radial arm saws are versatile but present serious hazards including kickbacks, blade contact, and flying debris.
To reduce these risks, OSHA mandates specific guarding, alignment, and automatic return features that ensure the blade is shielded and the saw arm resets to a safe position after each cut.
Radial saw accidents often involve kickback and blade contact injuries.
By requiring guards, anti-kickback devices, and automatic return features, OSHA 1926.304(g) minimizes these risks and enforces engineering controls to make saw use safer on construction sites.
Compliance prevents amputations, deep lacerations, and struck-by incidents.
OSHA 1926.304(g) works alongside 1926.304(h) (hand-fed crosscut table saws) and 1926.304(i) (hand-fed ripsaws),
as well as OSHA 1910.213 which governs woodworking machinery in general industry.
Together, these standards form a comprehensive framework for saw safety in both construction and general industry.
The automatic return ensures the saw blade moves back to the safe starting position when released, reducing the chance of accidental contact.
Yes, when used for ripping operations, a non-kickback device and spreader are required to prevent material from being thrown back at the operator.
OSHA 1926.304(g) applies specifically to construction job sites, while OSHA 1910.213(h) governs radial saws in general industry.